Search results
Results from the WOW.Com Content Network
It is a regenerative amplifier adjusted to provide positive feedback within the receiver. This has the effect of narrowing the receiver's bandwidth, as if the Q factor of its tuned circuits had been increased. The Q multiplier was a common accessory in shortwave receivers of the vacuum tube era as either a factory installation or an add-on ...
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
The type 36 screen-grid tube (obsolete since the mid-1930s) had a non-regenerative detection gain (audio frequency plate voltage divided by radio frequency input voltage) of only 9.2 at 7.2 MHz, but in a regenerative detector, had detection gain as high as 7,900 at critical regeneration (non-oscillating) and as high as 15,800 with regeneration ...
4 Join the "history" parts, please, and take out Superregenerator. 2 comments. 5 Concerning Description. 3 comments. 6 Leap of logic. 2 comments. 7 "Ham" is not an ...
A 5-tube superheterodyne receiver manufactured by Toshiba circa 1955 Superheterodyne transistor radio circuit circa 1975. A superheterodyne receiver, often shortened to superhet, is a type of radio receiver that uses frequency mixing to convert a received signal to a fixed intermediate frequency (IF) which can be more conveniently processed than the original carrier frequency.
The regenerative radio receiver obtained more gain out of one gain device by using positive feedback, but it required careful adjustment by the operator; that adjustment also changed the selectivity of the regenerative receiver. The superheterodyne provides a large, stable gain and constant selectivity without troublesome adjustment.
A shortwave radio receiver is a radio receiver that can receive one or more shortwave bands, between 1.6 and 30 MHz. A shortwave radio receiver often receives other broadcast bands, such as FM radio, Longwave and Mediumwave. Shortwave radio receivers are often used by dedicated hobbyists called shortwave listeners.
Therefore other methods may be used to increase selectivity, such as Q multiplier circuits and regenerative receivers. Superheterodyne receivers allow use one or more fixed intermediate frequency tuned circuits for selectivity. Fixed tuning eliminates the requirement that multiple tuning stages accurately match while being adjusted.