Search results
Results from the WOW.Com Content Network
Multiplexer; Like a scan configuration, multiplex switching can be used to connect one instrument to multiple devices (1:N) or multiple instruments to a single device (N:1), but it offers much more flexibility than the scanner configuration because it permits multiple simultaneous connections and both sequential and non-sequential switch closures.
A Charlieplexed digital clock which controls 90 LEDs with 10 pins of a PIC 16C54 microcontroller.. Charlieplexing (also known as tristate multiplexing, reduced pin-count LED multiplexing, complementary LED drive and crossplexing) is a technique for accessing a large number of LEDs, switches, micro-capacitors or other I/O entities, using relatively few tri-state logic wires from a microcontroller.
The DMS-100 is a member of the Digital Multiplex System (DMS) product line of telephone exchange switches manufactured by Northern Telecom. Designed during the 1970s and released in 1979, it can control 100,000 telephone lines. [1] The purpose of the DMS-100 Switch is to provide local service and connections to the PSTN public
An electronic multiplexer can be considered as a multiple-input, single-output switch, and a demultiplexer as a single-input, multiple-output switch. [3] The schematic symbol for a multiplexer is an isosceles trapezoid with the longer parallel side containing the input pins and the short parallel side containing the output pin. [4]
An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF ( radio frequency ) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT).
In electronics, a crossover switch or matrix switch is a switch connecting multiple inputs to multiple outputs using complex array matrices designed to switch inputs to outputs such that each output is connected to only one input, but usually inputs may be connected to multiple outputs. There are blocking and non-blocking types of cross-over ...
I and V sweeping—Sweep capabilities offer a way to test devices under a range of conditions with different source, delay and measure characteristics. These can include fixed level, linear/log and pulsed sweeps. On-board processor—Some SMUs further improve instrument integration, communication and test time by adding an on-board script ...
The switching or reconfiguration functions range from the manual fiber patch panel to a variety of switching technologies including microelectromechanical systems (MEMS), liquid crystal and thermo-optic switches in planar waveguide circuits. Although both have add/drop functionality, OADMs are distinct from add-drop multiplexers.