Search results
Results from the WOW.Com Content Network
A VLAN can also serve to restrict access to network resources without regard to physical topology of the network. [a] VLANs operate at the data link layer of the OSI model. Administrators often configure a VLAN to map directly to an IP network, or subnet, which gives the appearance of involving the network layer.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
Example without and with VTP. On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and ...
The idea is to provide, for example, the possibility for customers to run their own VLANs inside a service provider's provided VLAN. This way the service provider can just configure one VLAN for the customer and the customer can then treat that VLAN as if it were a trunk. IEEE 802.1ad was created for the following reasons:
Within a layer 2 network, MVRP provides a method to dynamically share VLAN information and configure the needed VLANs. For example, in order to add a switch port to a VLAN, only the end port, or the VLAN-supporting network device connected to the switch port need be reconfigured, and all necessary VLAN trunks are dynamically created on the ...
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst