Search results
Results from the WOW.Com Content Network
An F/A-18 taking off from an aircraft carrier An Embraer E175 taking off. Takeoff is the phase of flight in which an aerospace vehicle leaves the ground and becomes airborne. For aircraft traveling vertically, this is known as liftoff.
Short Take-Off and Vertical Landing or Conventional Take-off and Landing operation is preferred to VTOL operation. V/STOL was developed to allow fast jets to be operated from clearings in forests, from very short runways, and from small aircraft carriers that would previously only have been able to carry helicopters .
A takeoff/go-around switch (TO/GA; / ˈ t oʊ ɡ ə /) is a switch on the autothrottle of modern large aircraft, with two modes: takeoff (TO) and go-around (GA). The mode is dependent on the phase of flight; usually, on approach to land, the autopilot will be set to approach mode, therefore if the TO/GA switch is pressed it will activate the go-around mode of the autothrottle (about 90–92% ...
In a normal landing, the pilot flies the traffic pattern and establishes the aircraft on final approach.As the aircraft crosses the threshold of the runway the pilot executes the landing flare, touches the aircraft down, and immediately applies braking, ground spoilers, and (if available) reverse thrust until the aircraft has decelerated enough to exit onto a taxiway.
A Royal Australian Air Force aircraftswoman demonstrating the use of an oxygen mask during a pre-flight safety demonstration on board an Australian Airbus A330 MRTT. A pre-flight safety briefing (also known as a pre-flight demonstration, in-flight safety briefing, in-flight safety demonstration, safety instructions, or simply the safety video) is a detailed explanation given before take-off to ...
Three U.S. Air Force B-52G aircraft depart Barksdale AFB during a MITO exercise in 1986. A minimum interval takeoff (MITO) is a technique of the United States Air Force for scrambling all available bomber and tanker aircraft at twelve- and fifteen-second intervals, respectively. [1]
Upon each landing, depending on the runway distance remaining, aircraft and pilot capabilities, noise abatement procedures in effect, and air traffic control clearance, the pilot will perform either a full stop landing (taxi to the runway beginning for subsequent take-off), a touch-and-go (stabilize in the landing roll, reconfigure the aircraft ...
When the pilot is instructed or decides to go around, the pilot applies full thrust or a predetermined TOGA (Takeoff and Go Around) thrust to the engine(s), adopts an appropriate climb attitude and airspeed, raises the landing gear when the airplane has achieved a positive climb rate, retracts the flaps as necessary, follows the instructions of the control tower (in controlled airspace), and ...