Search results
Results from the WOW.Com Content Network
Seep is often used in environmental sciences to define an exfiltration zone (seepage zone) where contaminated water, e.g., from waste dumps, leaves a waste system area. Seeps are often important smaller wildlife water sources, and indicated by lower riparian vegetation.
Groundwater is water that is found underground in cracks and spaces in the soil, sand and rocks. Where water has filled these spaces is the phreatic (also called) saturated zone. Groundwater is stored in and moves slowly (compared to surface runoff in temperate conditions and watercourses) through layers or zones of soil, sand and rocks: aquifers.
Internal erosion is the formation of voids within a soil caused by the removal of material by seepage. [1] It is the second most common cause of failure in levees and one of the leading causes of failures in earth dams, [2] responsible for about half of embankment dam failures. [3]
Canal Lining. Canal lining is the process of reducing seepage loss of irrigation water by adding an impermeable layer to the edges of the trench. Seepage can result in losses of 30 to 50 percent of irrigation water from canals, so adding lining can make irrigation systems more efficient.
The top flow line of a saturated soil mass below which seepage takes place, is called the Phreatic line. Hydrostatic pressure acts below the phreatic line whereas atmospheric pressure exists above the phreatic line. This line separates a saturated soil mass from an unsaturated soil mass. It is not an equipotential line, but a flow line.
A soil test is a laboratory or in-situ analysis to determine the chemical, physical or biological characteristics of a soil. Possibly the most widely conducted soil tests are those performed to estimate the plant-available concentrations of nutrients in order to provide fertilizer recommendations in agriculture.
SEEP2D is a 2D seepage analysis program written by Dr. Fred Tracy of the United States Army Corps of Engineers. The program is used to analyze water seepage, typically through dams and levees or under sheet piles. "The model is internationally known in the engineering community as a model for complicated seepage analysis of dams and levees."
Groundwater pollution (also called groundwater contamination) occurs when pollutants are released to the ground and make their way into groundwater.This type of water pollution can also occur naturally due to the presence of a minor and unwanted constituent, contaminant, or impurity in the groundwater, in which case it is more likely referred to as contamination rather than pollution.