enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Miter saw - Wikipedia

   en.wikipedia.org/wiki/Miter_saw

   A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...

3. Delta Machinery - Wikipedia

   en.wikipedia.org/wiki/Delta_Machinery

   10" Unisaw RS830 10" Radial Arm Saw 28-206 14" Band Saw: Parent: Chang Type Industrial Co., Ltd. ... In 1966, Rockwell invented the world's first power miter saw.

4. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.

5. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   These saws are characterized by a cast iron top on a full-length steel base, generally square in section, with radiused corners. Two 3 ⁄ 4-inch-wide (19 mm) miter slots (1 inch [25 mm] wide on the largest saws) are located parallel to the blade, one to the left of the blade and one to the right.

6. 'Boy in the Box' Was Found Slain, Severely Beaten and Nude ...

   www.aol.com/boy-box-found-slain-severely...

   Two years after finally being identified, the "Boy in the Box" case continues to haunt Philadelphia. The slain body of Joseph Augustus Zarelli, 4, was discovered in February 1957 in Philadelphia's ...

7. Backsaw - Wikipedia

   en.wikipedia.org/wiki/Backsaw

   Carcass saw – an in-between of a tenon saw and a dovetail saw. Dovetail saw – a small backsaw used to cut dovetails . These saws will usually have a higher number of teeth per inch (around 15 - 20 T.P.I.) with teeth sharpened in a rip tooth pattern and minimal set to leave a narrow kerf.