Search results
Results from the WOW.Com Content Network
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B /s, i.e. 8 GB/s, or approximately 7.45 GiB /s.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits , kilobits , or bits per second.
The physical layer net bitrate, [12] information rate, [6] useful bit rate, [13] payload rate, [14] net data transfer rate, [9] coded transmission rate, [7] effective data rate [7] or wire speed (informal language) of a digital communication channel is the capacity excluding the physical layer protocol overhead, for example time division ...
In telecommunications, effective data transfer rate is the average number of units of data, such as bits, characters, blocks, or frames, transferred per unit time from a source and accepted as valid by a sink. Note: The effective data transfer rate is usually expressed in bits, characters, blocks, or frames per second. The effective data ...
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...
Symbol rate or baud rate, the number of symbol changes, waveform changes, or signaling events across the transmission medium per unit of time; Data-rate units, measures of the bit rate or baud rate of a link; Data transfer rate (disk drive), a data rate specific to disk drive operations