enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating current; therefore, a small increase in applied voltage greatly increases the current.

3. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .

4. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.

5. SMD LED - Wikipedia

   en.wikipedia.org/wiki/SMD_LED

   The light from white LED lamps and LED strip lights is usually provided by industry standard surface-mounted device LEDs (SMD LEDs). [2] Non-SMD types of LED lighting also exist, such as COB (chip on board) and MCOB (multi-COB). Surface-mounted device LED modules are described by the dimensions of the LED package. A single multicolor module may ...

6. Thermal management of high-power LEDs - Wikipedia

   en.wikipedia.org/wiki/Thermal_management_of_high...

   LED power dissipation is modeled as a current source; thermal resistance is modeled as a resistor; and the ambient temperature is modeled as a voltage source. High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light – about 70% heat and 30% light. [1]

7. Through-hole technology - Wikipedia

   en.wikipedia.org/wiki/Through-hole_technology

   Through-hole (leaded) resistors. In electronics, through-hole technology (also spelled "thru-hole") is a manufacturing scheme in which leads on the components are inserted through holes drilled in printed circuit boards (PCB) and soldered to pads on the opposite side, either by manual assembly (hand placement) or by the use of automated insertion mount machines.