Ad
related to: using furring strips for drywall dimensions chart size mm size 2
Search results
Results from the WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Typical dimensions of today's "two by four" is 1.5 by 3.5 inches (38 mm × 89 mm) dimensional lumber prior to sanding and are typically placed 16 inches (406 mm) from each other's center, but sometimes also at 12 inches (305 mm) or 24 inches (610 mm).
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.
Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...
In flooring a batten may be relatively large, up to 2.5 inches (6.4 cm) thick by 7 inches (18 cm) wide and more than 6 feet (1.8 m) long. [4] Battens may also be used to secure carpet in place, where they are sometimes referred to as "gripper strips". [5] [6]
Metal lath and plaster walls can be twice as resistant to fire as drywall, and are capable of achieving a two-hour fire rating with a 2-inch-thick (5.1 cm) assembly. Two inches of plaster and lath can also achieve the same decibel rating as 4 + 7 ⁄ 8 inches (12 cm) of drywall. [15]
8-inch (200 mm) hollow CMU (concrete masonry unit) with 1 + 1 ⁄ 2-inch (38 mm) wood furring, 1 + 1 ⁄ 2-inch fiberglass insulation and 1 ⁄ 2-inch (13 mm) drywall on each side [35] 55 Double layer of 1 ⁄ 2-inch (13 mm) drywall on each side, on staggered wood stud wall, batt insulation in wall 59
The name Molly was formerly trademarked [2] but is now often used in generic reference. Other names used for this same general type of fastener include hollow-wall anchor and hollow-door anchor , sometimes with design variations but always with the same design theme of expansion via deformation as the screw is tightened.
Ad
related to: using furring strips for drywall dimensions chart size mm size 2