Search results
Results from the WOW.Com Content Network
Structural integrity may be compromised, e.g., by misalignment during drilling, so that too much copper may be removed by the drill hole in the area where a trace connects to the pad or via. [ 2 ] [ 3 ] [ 5 ] An extra advantage is the enlarging of manufacturing tolerances, making manufacturing easier and cheaper.
Parts books were often issued as microfiche, though this has fallen out of favour. Now, many manufacturers offer this information digitally in an electronic parts catalogue. This can be locally installed software, or a centrally hosted web application. Usually, an electronic parts catalogue enables the user to virtually disassemble the product ...
DipTrace is a proprietary software suite for electronic design automation (EDA) used for electronic schematic capture and printed circuit board layouts. DipTrace has four applications: schematic editor, PCB editor with built-in shape-based autorouter and 3D preview, component editor (schematic symbol), and pattern editor (PCB footprint).
Decapping (decapsulation) or delidding of an integrated circuit (IC) is the process of removing the protective cover or integrated heat spreader (IHS) of an integrated circuit so that the contained die is revealed for visual inspection of the micro circuitry imprinted on the die.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
Some electronics simulators integrate a schematic editor, a simulation engine, and an on-screen waveform display (see Figure 1), allowing designers to rapidly modify a simulated circuit and see what effect the changes have on the output. They also typically contain extensive model and device libraries.
Even after the introduction of printed circuit boards, it did not require laying out and manufacturing circuit boards. Point-to-point and terminal strip construction continued to be used for some vacuum tube equipment even after the introduction of printed circuit boards. The heat of the tubes can degrade the circuit boards and cause them to ...