Search results
Results from the WOW.Com Content Network
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. 4. Contact your Internet Service Provider (ISP) - If you're still not able to get online, reach out to your ISP for additional help.
The person at computer B issues the modem escape command. (Alternately, and more commonly, the computer B could drop the DTR, or Data Terminal Ready signal, to achieve a hangup, without needing to use +++ or ATH.) OK: The modem acknowledges it. ATH: The person at computer B issues a hang up command. NO CARRIER: OK
The modem uses the Data Carrier Detect (DCD) pin to signal whether it's connected to a host. The computer can generally just read the DCD pin at any time and always know if the modem is in command or data mode. DCD high means data mode, and low means command mode. DCD is a signal sent from the modem to the computer.
[3] [4] Devices may not have a dedicated Reset button, but have the user hold the power button to cut power, which the user can then turn the computer back on. [5] Out-of-band management also frequently provides the possibility to reset the remote system in this way.
Microsoft's Windows 8, Windows 10 and Windows 11, and Apple's macOS have options for this. [citation needed] On Android devices, there is a factory data reset [4] option in Settings that will appear to erase all of the device's data and reset all of its settings. This method is typically used when the device has a technical problem that cannot ...
The calling modem waits for the tone after it dials the phone line before it initiates data transmission. If it does not receive a carrier tone within a set amount of time, it will disconnect the phone line and issues the NO CARRIER message. The actual data is transmitted from the answering modem to the calling modem via modulation of the carrier.
The method for recording audio data is the same, except that the command is AT+VRX, or AT#VRX, and the modem transmits audio data while the computer receives it. The RTS/CTS flow control are not used here (the computer must accept all the audio data it receives, and the modem automatically paces its transmission to match the audio sampling rate).
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.