Search results
Results from the WOW.Com Content Network
for AC having a supply frequency of 50, 60 or 400Hz, though the use of other frequencies for special purposes is not excluded. This includes low-voltage installations, as found in most domestic and commercial properties, and extra-low-voltage systems, but excludes high voltage , as found in generation, transmission and distribution networks.
SY Cables are NOT just for control, and can be used in fixed wiring installations, so long as the specifications are followed, they also have a screen which prevents some EMI) SY cable should not be used in areas exposed to ultraviolet light as it damages the outer sheath leading to cracking and then rusting of the braid as water penetrates the ...
Special wiring rules apply to wet or corrosive locations, [13] and to locations which present an explosion hazard. [14] Wiring materials for use in the United States must generally be made and tested to product standards set by NEMA and Underwriters Laboratories (UL) and must bear approval marks such as those set by UL.
IP phone systems can run the telephone and the computer on the same wires, eliminating the need for separate phone wiring. Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends.
7.2 Equipment intended for fixed installation with internal connections to the data link Fixed installation products with internal connections to the data link may use the 5-pin XLR connector, but shall not use any other XLR connector. When use is made of the 5-pin XLR connector, the requirements of 7.1 and 7.1.1 shall apply.
The front panel data port (FPDP) is a bus that provides high speed data transfer between two or more VMEbus boards at up to 160 Mbit/s with low latency. The FPDP bus uses a 32-bit parallel synchronous bus wired with an 80-conductor ribbon cable. [1] The following interface functions are supported: [2]
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
TIA-530 originally used Category I circuits for what is commonly called "Data Set Ready" (DCE Ready, pins 6 and 22) and "Data Terminal Ready" (DTE Ready, pins 20 and 23). Revision A [ 2 ] changed these interchange circuits to Category II (para 4.3.6 and 4.3.7 of the standard [ 3 ] ) and added a "Ring Indicator" on pin 22.