Search results
Results from the WOW.Com Content Network
In computing, the BIOS parameter block, often shortened to BPB, is a data structure in the volume boot record (VBR) describing the physical layout of a data storage volume. On partitioned devices, such as hard disks , the BPB describes the volume partition, whereas, on unpartitioned devices, such as floppy disks , it describes the entire medium.
The boot code in the VBR can assume that the BIOS has set up its data structures and interrupts and initialized the hardware. The code should not assume more than 32 KB of memory to be present for fail-safe operation; [1] if it needs more memory it should query INT 12h for it, since other pre-boot code (such as f.e. BIOS extension overlays, encryption systems, or remote bootstrap loaders) may ...
DOS 3.0 BIOS Parameter Block (little-endian format) 0x01E varies Private boot sector data (mixed big-endian and little-endian format) varies varies File system and operating system specific Atari ST boot code. No assumptions must be made in regard to the load position of the code, which must be relocatable.
The BIOS does not interpret the contents of the boot sector other than to possibly check for the boot sector signature in the last two bytes. Interpretation of data structures like partition tables and BIOS Parameter Blocks is done by the boot program in the boot sector itself or by other programs loaded through the boot process.
To programmatically determine which file system a BDP contains, Microsoft specifies that one should inspect the BIOS Parameter Block that is contained in the BDP's Volume Boot Record. When a Microsoft operating system converts a GPT-partitioned basic disk to a dynamic disk , all BDPs are combined and converted to a single Logical Disk Manager ...
To use this call, load AH with the number of the desired subfunction, load other required parameters in other registers, and make the call. INT 10h is fairly slow, so many programs bypass this BIOS routine and access the display hardware directly. Setting the video mode, which is done infrequently, can be accomplished by using the BIOS, while ...
1. Click the Block Senders tab. 2. In the box under "Block mail from addresses I specify," enter the email address you want blocked. 3. Click the + icon 4. Alternatively, to remove the address, click the X icon next to the address you want removed.
With this option, Format writes bootstrap code to the first sector of the volume (and possibly elsewhere as well). Format always writes a BIOS Parameter Block to the first sector, with or without the /S option. Another option (/Q) allows for what Microsoft calls "Quick Format". With this option the command will not perform steps 2 and 3 above.