Search results
Results from the WOW.Com Content Network
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification. It is primarily a means of testing the communications infrastructure. Loopback can take the form of communication channels with only one communication endpoint.
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer. Ethernet Configuration Testing Protocol was implemented on DEC hosts and Cisco routers. [2]
By far the most popular FCS algorithm is a cyclic redundancy check (CRC), used in Ethernet and other IEEE 802 protocols with 32 bits, in X.25 with 16 or 32 bits, in HDLC with 16 or 32 bits, in Frame Relay with 16 bits, [3] in Point-to-Point Protocol (PPP) with 16 or 32 bits, and in other data link layer protocols.
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM).This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs).
In computer networking, localhost is a hostname that refers to the current computer used to access it. The name localhost is reserved for loopback purposes. [1] It is used to access the network services that are running on the host via the loopback network interface.
Download and install the latest Java Virtual Machine in Internet Explorer. 1. Go to www.java.com. 2. Click Free Java Download. 3. Click Agree and Start Free Download. 4. Click Run. Notes: If prompted by the User Account Control window, click Yes. If prompted by the Security Warning window, click Run. 5.
Ethernet II framing considered these octets to represent EtherType while the original IEEE 802.3 framing considered these octets to represent the size of the payload in bytes. In order to allow Ethernet II and IEEE 802.3 framing to be used on the same Ethernet segment, a unifying standard, IEEE 802.3x-1997, was introduced that required that ...
The value 51.2 μs is used as an example here because it is the slot time for a 10 Mbit/s Ethernet line. However, 51.2 μs could be replaced by any positive value, in practice. When a collision first occurs, send a jamming signal to prevent further data from being sent.