Ad
related to: sprue bushings for molds
Search results
Results from the WOW.Com Content Network
Sprue puller pin—The sprue puller pin pulls the sprue from the sprue bush. It is usually made of CHMCS; Core back plate—It holds the core insert in place and acts as a "stiffener". It is usually made of mild steel. Guide pillar and guide bushing — The guide pillar and guide bush align the fixed and moving halves of a mold in each cycle.
A sprue is a large diameter vertical channel through which liquid material is introduced into a mold. It connects the pouring basin to the runner. In many cases it controls the flow of material into the mold. During casting or molding, the material in the sprue will solidify and need to be removed from the finished part. It is usually tapered ...
Circular pattern around gate, normally only an issue on hot runner molds Injection speed is too fast, gate/sprue/runner size is too small, or the melt/mold temp is too low. Jetting: Jetting is a snake-like stream which occurs when polymer melt is pushed at a high velocity through restrictive areas. Poor tool design, gate position or runner.
Clean nozzle and sprue bushing by making few shots; Continue purging until most of the commercial purging material is out of the hopper; Feed at least one injection capacity of the next production resin to rinse out any residuals; Start the next production with new resin
A bronze casting showing the sprue and risers. A riser, also known as a feeder, [1] is a reservoir built into a metal casting mold to prevent cavities due to shrinkage.Most metals are less dense as a liquid than as a solid so castings shrink upon cooling, which can leave a void at the last point to solidify.
Cope and drag with cores in place on the drag Two sets of castings (bronze and aluminium) from the above sand mold. In foundry work, the terms cope and drag refer respectively to the top and bottom parts of a two-part casting flask, used in sand casting. The flask is a wood or metal frame, which contains the molding sand, providing support to ...
Mold cavity: The combined open area of the molding material and core, where the metal is poured to produce the casting. Riser: An extra void in the mold that fills with molten material to compensate for shrinkage during solidification. Gating system: The network of connected channels that deliver the molten material to the mold cavities.
In directional solidification growths of single crystals, spurious grains nucleate when molten metal flowed into a gap between the mold/seed gap and solidified. [10] This is catastrophic to mechanical properties of Ni-based superalloys such as CMSX4, and can be minimized by keeping the tolerance of <001> from the local surface normal. [ 11 ]
Ad
related to: sprue bushings for molds