enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Recloser - Wikipedia

   en.wikipedia.org/wiki/Recloser

   On a 3-phase circuit, a recloser is more beneficial than three separate fuse cutouts. For example, on a wye to delta conversion, when cutouts are used on the wye side and only 1 out of 3 of the cutout fuses open, some customers on the delta side have a low voltage condition, due to voltage transfer through the transformer windings. Low voltage ...

3. Three-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Three-phase_electric_power

   Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ [1]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [2]

4. Substation - Wikipedia

   en.wikipedia.org/wiki/Substation

   Often used in distribution, they often are programmed to trip when the amps exceed a certain amount over a period of time. Reclosers will attempt to re-energize the circuit after a delay. If unsuccessful for a few times, the recloser will have to be manually reset by an electrical worker. [45]

5. List of IEC standards - Wikipedia

   en.wikipedia.org/wiki/List_of_IEC_standards

   IEC 60724 Short-circuit temperature limits of electric cables with rated voltages of 1 kV (U m = 1,2 kV) and 3 kV (U m = 3,6 kV) IEC TR 60725 Consideration of reference impedances and public supply network impedances for use in determining the disturbance characteristics of electrical equipment having a rated current ≤75 A per phase

6. Electrical wiring in the United Kingdom - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_the...

   A three or four-pole isolator or circuit breaker is used for three-phase loads, for devices with both permanent and switched supplies (such as bathroom extractor fans) and also at the distribution board to isolate all the phases. A three-phase installation with a TT earthing system is an example where four-pole devices would be required.

7. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.