Search results
Results from the WOW.Com Content Network
The car also featured silver "Intimidator" SS badges on the right side of the trunk, and standard Monte Carlo SS badges on the bottom of the vehicle, just in front of the rear tires. An Intimidator badge with the number 3 also appeared on the dash, and Earnhardt's signature appeared on the gauge cluster.
The SS package was first made available for the 1961 Impala. [1] Some of the other models bearing the SS badge include the Camaro, Chevelle, El Camino, Impala, Monte Carlo, Nova and some trucks like the Silverado and S-10, as well as the TrailBlazer SUV. Current SS models are produced by the GM Performance Division.
English: 2004 Chevrolet Monte Carlo Intimidator SS photographed at the 2023 New Brighton Car Cruise in New Brighton, Pennsylvania. Date 9 September 2023, 12:29:21
Additionally, the intermediate Chevrolet Malibu and Monte Carlo also used the 229 cu in (3.8 L) as a replacement for both the 200 cu in (3.3 L) V6 and the 231 cu in (3.8 L) Buick V6. Checker Motors Corporation also used this engine starting with its 1980 A11 Taxi and A12 Marathon sedans. Both the Buick V6 and the 229 cu in (3.8 L) Chevrolet V6 ...
1978–1987 Chevrolet Monte Carlo This is very confusing, as Monte Carlo at various times used both the V6 from the Buick engine as well as the V6 engine derived from the Chevrolet V8. 1978–1980 Chevrolet Monza; 1978–1987 Oldsmobile Cutlass Supreme; 1975–1980 Oldsmobile Starfire; 1977–1979 Oldsmobile Omega; 1978–1987 Pontiac Grand Prix
Chevrolet Monte Carlo (1995–2005) Chevrolet Monte Carlo SS (2006–2007, use continued until 2008 in Nationwide Series) Chevrolet Impala (2009–2010, Nationwide Series only) Pontiac Grand Prix (1992–2004, no factory support after 2003, use continued until 2005 in Busch Series, and until 2007 in the ARCA Racing Series)
The Generation 3 refers to the generation of stock cars used in NASCAR from 1981 to 1991, and it was used in the Busch Series at it's modern beginning in 1982. In this generation, NASCAR downsized the cars to better resemble cars on the showroom floor (with wheelbase at 110 inches), and body panels were still purchased through the manufacturers.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.