Search results
Results from the WOW.Com Content Network
The Whisper family was developed as a line of accurate, multi-purpose cartridges using relatively heavy rifle bullets for a given caliber in subsonic loads. [ 1 ] [ 2 ] [ 3 ] The intention was to create an extremely accurate cartridge family for military, police, competition and specialized hunting markets that could also be easily sound ...
Subsonic ammunition is ammunition designed to operate at velocities below the speed of sound (Mach 1), which at standard conditions is 340.29 m/s (1,116.4 ft/s). This avoids the supersonic shockwave or "crack" of a supersonic bullet, which, particularly for suppressed firearms, influences the loudness of the shot.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
The DSR-1 Subsonic is a variant optimized for 7.62×51mm NATO/.308 Winchester subsonic ammunition usage. The barrel length is reduced to 310 mm. The barrel length is reduced to 310 mm. The 8 inch twist rate of the barrel is especially adapted to stabilize the long heavy projectiles used in subsonic ammunition.
The 7mm-08 with 139-140 grain loads does well against some 150-grain .308 Win. loads, providing good energy levels. One example is the Remington 7mm-08 140 PSP (1490 fpe at 300 yards) compared with the Remington 308 150 grain PSP (1344 fpe at 300 yards). [14] The 7mm-08 invites a ballistic comparison with the veteran, highly esteemed 7×57mm ...
To manufacture cases for cartridges, a sheet of brass is punched into disks. These disks go through a series of drawing dies. The disks are annealed and washed before moving to the next series of dies. The brass needs to be annealed to remove the work-hardening in the material and make the brass malleable again ready for the next series of dies ...
For example, if the muzzle velocity is reduced from 2,700 ft/s (820 m/s) (common for the .308 Winchester, for example) to a subsonic 950 ft/s (290 m/s), the muzzle energy is reduced by a factor of 8. Military marksmen and police units may use subsonic ammunition in suppressed rifles when minimal noise is more important than range and energy. [58]
7.62mm Thumper is a barrel specification optimized to run larger bullets out of standard 7.62×39mm cases. [1] Barrels are cut to a standard 7.62×39mm "Russian" chamber but the bore ideally uses a faster 1:8" rifling twist rate in order to stabilize bullets heavier than 200gr at subsonic speeds. [2]