Search results
Results from the WOW.Com Content Network
These cylinders, two or more, are connected to one pipe that is filled with oil, the basic fluid used for a hydraulic system. The cylinders are used to establish compression pressure of the oil, fluid being supplied by the pump, to push the automobile up. [7] The motion of car is defined by the number of cylinder pumps installed in the vehicle.
Fluid flow in an external gear pump. A hydraulic pump is a mechanical source of power that converts mechanical power into hydraulic energy (hydrostatic energy i.e. flow, pressure). Hydraulic pumps are used in hydraulic drive systems and can be hydrostatic or hydrodynamic. They generate flow with enough power to overcome pressure induced by a ...
A hydraulic fluid or hydraulic liquid is the medium by which power is transferred in hydraulic machinery. Common hydraulic fluids are based on mineral oil or water. [ 1 ] Examples of equipment that might use hydraulic fluids are excavators and backhoes , hydraulic brakes , power steering systems, automatic transmissions , garbage trucks ...
Hydraulic hybrid vehicle systems consists of four main components: the working fluid, reservoir, pump/motor (in parallel hybrid system) or in-wheel motors and pumps (in series hybrid system), and accumulator. In some systems, a hydraulic transformer is also installed for converting output flow at any pressure with a very low power loss. [3]
When the car is too low, the height corrector valve opens to allow more fluid into the suspension cylinder (e.g., the car is loaded). When the car is too high (e.g. after unloading) fluid is returned to the system reservoir via low-pressure return lines. Height correctors act with some delay in order not to correct regular suspension movements.
A fluid coupling consists of three components, plus the hydraulic fluid: The housing, also known as the shell [5] (which must have an oil-tight seal around the drive shafts), contains the fluid and turbines. Two turbines (fanlike components): One connected to the input shaft; known as the pump or impeller, [5] or primary wheel input turbine. [5]
Components of a hydraulic system [sources (e.g. pumps), controls (e.g. valves) and actuators (e.g. cylinders)] need connections that will contain and direct the hydraulic fluid without leaking or losing the pressure that makes them work. In some cases, the components can be made to bolt together with fluid paths built-in.
In the ABC system, a computer detects body movement from sensors located throughout the vehicle, and controls the action of the active suspension with the use of hydraulic servomechanisms. The hydraulic pressure to the servos is supplied by a high pressure radial piston hydraulic pump, operating at 3,000psi.