Search results
Results from the WOW.Com Content Network
Mixing the two compounds forms a barium sulfate precipitate, which causes turbidity in the solution. A 0.5 McFarland standard is prepared by mixing 0.05 mL of 1.175% barium chloride dihydrate (BaCl 2 •2H 2 O), with 9.95 mL of 1% sulfuric acid (H 2 SO 4 ).
Although nearly 100% sulfuric acid solutions can be made, the subsequent loss of SO 3 at the boiling point brings the concentration to 98.3% acid. The 98.3% grade, which is more stable in storage, is the usual form of what is described as "concentrated sulfuric acid".
The amine concentration in the absorbent aqueous solution is an important parameter in the design and operation of an amine gas treating process. Depending on which one of the following four amines the unit was designed to use and what gases it was designed to remove, these are some typical amine concentrations, expressed as weight percent of ...
High-pressure jets of hot seawater were used to clean the tanks, and the mixture of seawater and residue called slops was discharged into the sea, as was the oil-contaminated ballast water. The 1954 OILPOL Convention attempted to reduce the harm by prohibiting such discharges within 50 miles (80 km) of most land and 100 miles (160 km) of ...
This page contains tables of azeotrope data for various binary and ternary mixtures of solvents. The data include the composition of a mixture by weight (in binary azeotropes, when only one fraction is given, it is the fraction of the second component), the boiling point (b.p.) of a component, the boiling point of a mixture, and the specific gravity of the mixture.
[6] [d] The preparation of aqua regia by directly mixing hydrochloric acid with nitric acid only became possible after the discovery in the late sixteenth century of the process by which free hydrochloric acid can be produced. [8] The fox in Basil Valentine's Third Key represents aqua regia, Musaeum Hermeticum, 1678
In titrations, the concentration of analyte in solution can be determined by titrating the standard solution against the analyte solution to determine the threshold of neutralization. [9] For example, to calculate the concentration of hydrogen chloride, a standard solution of known concentration, such as 0.5 M sodium hydroxide, is titrated ...
3) Acid solution with an activity of H + = 1 mol/L, 4) Hydroseal for prevention of oxygen interference, 5) Reservoir via which the second half-element of the galvanic cell should be attached. The connection can be direct, through a narrow tube to reduce mixing, or through a salt bridge, depending on the other electrode and solution. This ...