Search results
Results from the WOW.Com Content Network
A wireless identification and sensing platform (WISP) is an RFID (radio-frequency identification) device that supports sensing and computing: a microcontroller powered by radio-frequency energy. [1] That is, like a passive RFID tag, WISP is powered and read by a standard off-the-shelf RFID reader, harvesting the power it uses from the reader's ...
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
Wireless light switches eliminate the wire from the light to the switch location. This is useful in remodelling situations where new wiring can be a hassle. Rather than tearing down a wall to gain access to the wires, a wireless switch can be used. This avoids any need to access wires and makes remodelling fast and simple.
NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module.
To sweep a servo with an Arduino, connect the servo's VCC (red wire) to 5V, GND (black/brown) to GND, and signal (yellow/white) to a PWM-capable pin (e.g., Pin 9). Use the Servo library to control movement. The code below gradually moves the servo from 0° to 180° and back in a loop.
The blink video doorbell is a wirelessly connected smart device that allows video and audio to be viewed via another device. It works similarly to the Ring doorbell, including in its ability to connect to Amazon Alexa and an offering of a "plus" subscription, which allows greater cloud storage capacity and syncing of multiple devices. [9] [10] [11]
For Wide SCSI-2, the most common connector was the larger 68-pin sibling of the HD50, known as the HD68, MiniD68, HPDB68, and sometimes as "SCSI-3". This is about 1 7/8” (47mm) wide. [ 3 ] IBM used the HDCN68 on some RS-6000 systems, and it seems likely that a few other manufacturers used other alternatives.