Search results
Results from the WOW.Com Content Network
A linear amplifier is an electronic circuit whose output is proportional to its input, but capable of delivering more power into a load. The term usually refers to a type of radio-frequency (RF) power amplifier , some of which have output power measured in kilowatts , and are used in amateur radio .
The second amplifier released was the Phase Linear 400 with 200 watts per channel. It shared the same distinctive brushed aluminum, dual VU meters front panel style as the 700. It retailed for just under $500. [1] The next product was the Phase Linear 4000 Series Auto-correlation Pre-Amplifier introduced in 1973 and manufactured through 1978.
2.5 W audio power amplifier (fixed 34 dB gain) [43] LM383/LM2002 Yes 8 W audio power amplifier: LM384 5 W audio power amplifier (fixed 34 dB gain) [44] LM1875 20 W audio power amplifier (up to 90 dB gain) [45] LM1876 Dual 20 W audio power amplifier with Mute and Standby Modes (up to 90 dB gain) [46] LM386: Low voltage audio power amplifier [47 ...
In 1987, Crown introduced the Macrotech 2400, capable of driving 100-volt lines directly. [3] Since then, further developments in high-power amplifier technology have widened the choices. Many manufacturers make amplifiers capable of direct connection to a high-impedance constant-voltage speaker line.
Most of the amplifiers produced by ACC were solid-state, but a few models later in production were valve amps. The company is remembered in particular for its Acoustic 361 bass stack, consisting of an Acoustic 360 bass pre-amplifier and one or two Acoustic 361 W-bins, each featuring a built-in 200-watt RMS power amplifier and a rear-facing 18" Cerwin-Vega loudspeaker.
Block diagram of a basic class-D amplifier. Note: For clarity, signal periods are not shown to scale. A class-D amplifier, or switching amplifier, is an electronic amplifier in which the amplifying devices (transistors, usually MOSFETs) operate as electronic switches, and not as linear gain devices as in other amplifiers.
Using a double triode (typically octal or noval) to form a SET input buffer (giving gain) to then feed a concertina phase splitter is a classic push–pull front end, typically followed by a driver (triode) and (triode or pentode) output stage (in ultra linear in many cases) to form the classic push–pull amplifier circuit.
The GU-50 (Russian: ГУ-50) is a power pentode vacuum tube intended for 50 watt operation as a linear RF amplifier on frequencies up to 120 MHz. It is, in fact, a Soviet-produced copy of the Telefunken LS-50 power pentode, [ 1 ] possibly reverse-engineered from German ( Wehrmacht ) military radios captured during World War II , or based on ...