Search results
Results from the WOW.Com Content Network
Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:
Tire identification labels. Automotive tires are described by several alphanumeric tire codes (in North American English) or tyre codes (in Commonwealth English), which are generally molded into the sidewall of the tire. These codes specify the dimensions of the tire and its key limitations, such as load-bearing ability and maximum speed.
UTQG ratings on sidewall of Toyo Tires Proxes R39 tire UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction.
For passenger and light truck tyres, the manufacturers or importers have the choice of either putting a sticker on the tyre tread or a label accompanying each delivery of batch of tyres to the dealer and to the end consumer. The tyre label will use a classification from the best (green category "A") to the worst performance (red category "G").
The European Tyre and Rim Technical Organisation (ETRTO) exists to specify and harmonise sizes of rims and their associated pneumatic tyres across the European Union.ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles.
A tire bead is held in the groove by air pressure. A bead breaker is a tool used for separating tires from rims. The innermost diameter of the tire that interfaces with the rim of a wheel is called the tire bead. The bead is a thicker section of rubber, and is reinforced with braided steel cables, called the bead bundle. [1]
Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases.
SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...