Search results
Results from the WOW.Com Content Network
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
A flap is a high-lift device used to reduce the stalling speed of an aircraft wing at a given weight. Flaps are usually mounted on the wing trailing edges of a fixed-wing aircraft. Flaps are used to reduce the take-off distance and the landing distance. Flaps also cause an increase in drag so they are retracted when not needed.
Blown flaps of the Hunting H.126. Blown flaps, blown wing or jet flaps are powered aerodynamic high-lift devices used on the wings of certain aircraft to improve their low-speed flight characteristics. They use air blown through nozzles to shape the airflow over the rear edge of the wing, directing the flow downward to increase the lift ...
The triple-slotted trailing edge flaps are well displayed and the Krueger flaps on the leading edge also are visible. In aircraft design and aerospace engineering, a high-lift device is a component or mechanism on an aircraft's wing that increases the amount of lift produced by the wing. The device may be a fixed component, or a movable ...
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
Droop flaps function with other high-lift devices on an aircraft to increase the camber of the wing and reduce the stalling speed.On the Airbus A380, the first stage of lift device selection deploys the droop flaps (called droop noses by Airbus) and leading-edge slats located further out on the wing; with the main flaps starting to extend when the second stage is selected.
Aircraft that regularly operate in icing conditions have systems to detect and prevent ice forming (anti-icing) and/or remove the ice accumulation after it has formed (de-icing). This can be achieved by heating the spaces in internal structure with engine bleed air, chemical treatment, electrical heating and expansion/contraction of the skin ...
An aircraft 'rolling', or 'banking', with its ailerons An aileron and roll trim tab of a light aircraft. An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft. [1]