Search results
Results from the WOW.Com Content Network
Seep is often used in environmental sciences to define an exfiltration zone (seepage zone) where contaminated water, e.g., from waste dumps, leaves a waste system area. Seeps are often important smaller wildlife water sources, and indicated by lower riparian vegetation.
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
Groundwater is water that is found underground in cracks and spaces in the soil, sand and rocks. Where water has filled these spaces is the phreatic (also called) saturated zone. Groundwater is stored in and moves slowly (compared to surface runoff in temperate conditions and watercourses) through layers or zones of soil, sand and rocks: aquifers.
Internal erosion is the formation of voids within a soil caused by the removal of material by seepage. [1] It is the second most common cause of failure in levees and one of the leading causes of failures in earth dams, [2] responsible for about half of embankment dam failures. [3]
The top flow line of a saturated soil mass below which seepage takes place, is called the Phreatic line. Hydrostatic pressure acts below the phreatic line whereas atmospheric pressure exists above the phreatic line. This line separates a saturated soil mass from an unsaturated soil mass. It is not an equipotential line, but a flow line.
A soil test is a laboratory or in-situ analysis to determine the chemical, physical or biological characteristics of a soil. Possibly the most widely conducted soil tests are those performed to estimate the plant-available concentrations of nutrients in order to provide fertilizer recommendations in agriculture.
SEEP2D is a 2D seepage analysis program written by Dr. Fred Tracy of the United States Army Corps of Engineers. The program is used to analyze water seepage, typically through dams and levees or under sheet piles. "The model is internationally known in the engineering community as a model for complicated seepage analysis of dams and levees."
The quick condition of soil is the condition when the upward water pressure gradient and water flow reduce the effective stress, i.e., cohesiveness of the soil. Sandy soils may lose their shear strength, and the soil may behave as a fluid. Cohesive soils may produce cracks with water seepage. [1] [2] [3] [4]