Search results
Results from the WOW.Com Content Network
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART supports 9-bit characters in addition to the 5- to 8-bit characters that other UARTs support. This was introduced by Oxford Semiconductor, which is now owned by PLX Technology.
The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications. The corrected -A version was released in 1987 by National Semiconductor . [ 1 ]
Pmod interface (peripheral module interface) is an open standard defined by Digilent in the Pmod Interface Specification [1] for connecting peripheral modules to FPGA and microcontroller development boards using 6 pins. Pmod or Pmods may also refer to modules compatible with the Pmod interface.
The pseudocode below outlines a software implementation ("bit-banging") of SPI's protocol as a main with simultaneous output and input. This pseudocode is for CPHA=0 and CPOL=0, thus SCLK is pulled low before CS is activated and bits are inputted on SCLK's rising edge while bits are outputted on SCLK's falling edge.
Modern devices use an integrated circuit called a UART to implement a serial port. This IC converts characters to and from asynchronous serial form, implementing the timing and framing of data specified by the serial protocol in hardware. The IBM PC implements its serial ports, when present, with one or more UARTs.
softavrcore, [55] written in Verilog, implements the AVR instruction set up to AVR5, supports interrupts along with optional automatic interrupt acknowledgement, power saving via sleep mode plus some peripheral interfaces and hardware accelerators (such as UART, SPI, cyclic redundancy check calculation unit and system timers). These peripherals ...
When start bit length is used to determine the baud rate, it requires the character to be odd since UART sends LSB bit first – this particular bit order scheme is referred to as little-endian. [2] Often symbols 'a' or 'A' (0x61 or 0x41) are used. For example, the MPC8270 SCC tries to detect the length of the UART start bit for autobaud.