enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   Strain gauge: a device used to measure the strain of an object. Thread pitch gauge, also called a threading gauge, pitch gauge, or screw gauge a device used to measure the pitch or lead of screw threads. Vernier height gauge: a measuring device used either for determining the height of something, or for repetitious marking of items to be worked on.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   "Sweating" is a term sometimes used to describe the soldering of pipe joints. [citation needed] [28] Where many connections must be made in a short period (such as plumbing of a new building), soldering is quicker and less expensive joinery than compression or flare fittings. A degree of skill is needed to make several reliable soldered joints ...

4. List of measuring instruments - Wikipedia

   en.wikipedia.org/wiki/List_of_measuring_instruments

   Lux meter for measuring illuminance, i.e. incident luminous flux per unit area; Luminance meter for measuring luminance, i.e. luminous flux per unit area and unit solid angle; Light meter, an instrument used to set photographic exposures. It can be either a lux meter (incident-light meter) or a luminance meter (reflected-light meter), and is ...

5. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

6. List of electrical and electronic measuring equipment

   en.wikipedia.org/wiki/List_of_electrical_and...

   Displays waveform of a signal, allows measurement of frequency, timing, peak excursion, offset, ... Psophometer: Measures AF signal level and noise Q meter: Measures Q factor of the RF circuits Tachometer: Measures speed of motors Signal analyzer: Measures both the amplitude and the modulation of a RF signal Signal generator

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.

8. Bore gauge - Wikipedia

   en.wikipedia.org/wiki/Bore_gauge

   The gauge is then removed and measured with the aid of a micrometer anvil heads, move the head of the gauge around while making the measurement to ensure you get the maximum reading. Grasp the gauge near the head to aid in your maneuvering of the gauge while adjusting the micrometer so it just stops the gauge's motion at one spot only.

9. Birmingham gauge - Wikipedia

   en.wikipedia.org/wiki/Birmingham_gauge

   The Birmingham gauge ranges from 5/0 or 00000, the lowest gauge number corresponding to the largest size of 0.500 inches (12.7 mm), to 36, the highest gauge number corresponding to the smallest size of 0.004 inches (0.10 mm). The increments between gauge sizes are not linear and vary. [2]