Search results
Results from the WOW.Com Content Network
Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.
Bi-amping is the use of two channels of amplification to power each loudspeaker within an audio system. Tri-amping is the practice of connecting three channels of amplification to a loudspeaker unit: one to power the bass driver , one to power the mid-range and the third to power the treble driver .
PLC allows for data communication over existing power lines, which can be particularly useful in environments where it's difficult to lay new wiring or where wireless communication might be problematic. IEEE 1901-2010: This was the initial standard that set the groundwork for broadband over power lines (BPL) and in-home powerline networks. It ...
Overhead power lines are often equipped with a ground conductor (shield wire, static wire, or overhead earth wire). The ground conductor is usually grounded (earthed) at the top of the supporting structure, to minimize the likelihood of direct lightning strikes to the phase conductors. [ 18 ]
Power line adapter. Power-line communication (PLC) is the carrying of data on a conductor that is also used simultaneously for AC electric power transmission or electric power distribution to consumers. The line that does so is known as a power-line carrier. In the past, power lines were solely used for transmitting electricity. However, with ...
A simple electric circuit made up of a voltage source and a resistor. Here, =, according to Ohm's law. An electrical network is an interconnection of electrical components (e.g., batteries, resistors, inductors, capacitors, switches, transistors) or a model of such an interconnection, consisting of electrical elements (e.g., voltage sources, current sources, resistances, inductances ...
Bill Gates wants to build more high-voltage power lines. It’s the best way to support high electricity demand, he says. But there's a big problem.
In a typical bi/tri/whatever speaker system, typically a device known as an active crossover sits between the line-level source of each amplifier, taking the full bandwidth line level signal from say a mixing console, as an input and outputting multiple line level signals for input to each of the amplifier/speaker systems.