Search results
Results from the WOW.Com Content Network
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
Blocking may also provide spacers or attachment points between adjoining stud walls, for example, where an interior and exterior wall meets, or at a corner where techniques such as the "three-stud corner with blocking" are used. [2]
A soffit is an exterior architectural feature, generally the horizontal, aloft underside of the roof edge. Its archetypal form, sometimes incorporating or implying the projection of rafters or trusses over the exterior of supporting walls, is the underside of eaves (to connect a supporting wall to projecting edge(s) of the roof ).
Fascia (/ ˈ f eɪ ʃ ə /) is an architectural term for a vertical frieze or band under a roof edge, or which forms the outer surface of a cornice, visible to an observer. [ 1 ] Typically consisting of a wooden board, unplasticized PVC (uPVC), or non-corrosive sheet metal, many of the non-domestic fascias made of stone form an ornately carved ...
A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw
The Roman Doric continues to be used. Fluted pilasters in that mode support a full entablature and modillioned cornice. On the ceiling are octagonal panels with rosettes at the center. From it hangs a bronze chandelier with two levels of electric candles. The wall sconces, corner lights and door clock are original. A 1934 map of Waterbury has ...
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.
The one working on top will do from the ceiling's edge to about belly height and work off a milk crate for an 8-foot (2.4 m) ceiling, or work off stilts for 12-foot-high rooms. For cathedral ceilings or very high walls, staging is set up and one works topside, the others further below. Clean up before they finish a job