Search results
Results from the WOW.Com Content Network
Carrier wave - Wikipedia
In this sense, the carrier wave, which has a much higher frequency than the message signal, carries the information. At the receiving station, the message signal is extracted from the modulated carrier by demodulation. In general form, a modulation process of a sinusoidal carrier wave may be described by the following equation: [2]
A low-frequency message signal (top) may be carried by an AM or FM radio wave. Waterfall plot of a 146.52 MHz radio carrier, with amplitude modulation by a 1,000 Hz sinusoid. Two strong sidebands at + and - 1 kHz from the carrier frequency are shown. A carrier, frequency modulated by a 1,000 Hz sinusoid.
The equation above shows that by multiplying the modulated signal by the carrier signal, the result is a scaled version of the original message signal plus a second term. Since , this second term is much higher in frequency than the original message. Once this signal passes through a low pass filter, the higher frequency component is removed ...
The peak amplitude and the frequency of the carrier signal are maintained constant, but as the amplitude of the message signal changes, the phase of the carrier changes correspondingly. Phase modulation is an integral part of many digital transmission coding schemes that underlie a wide range of technologies like Wi-Fi , GSM and satellite ...
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation. For example, with FM radio, the strength of the 100 MHz ...
Angle modulation is a class of carrier modulation that is used in telecommunications transmission systems. The class comprises frequency modulation (FM) and phase modulation (PM), and is based on altering the frequency or the phase, respectively, of a carrier signal to encode the message signal.
If the information to be transmitted (i.e., the baseband signal) is () and the sinusoidal carrier is () = (), where f c is the carrier's base frequency, and A c is the carrier's amplitude, the modulator combines the carrier with the baseband data signal to get the transmitted signal: [4] [citation needed]