Search results
Results from the WOW.Com Content Network
The aim of a measurement is to measure the surface on which the dial gauge or spirit level is placed horizontally. For example, to measure the angle of a wedge, the wedge is placed on a horizontal table. The sine bar is placed over the inclined surface of the wedge.
A dial test indicator, also known as a lever arm test indicator or finger indicator, has a smaller measuring range than a standard dial indicator. A test indicator measures the deflection of the arm, the probe does not retract but swings in an arc around its hinge point.
For example, all depths of cut in lathe work must account for whether they apply to the radius (that is, per side) or to the diameter (that is, total). Similarly, in shaft-straightening operations, where calibrated amounts of bending force are applied laterally to the shaft, the "total" emphasis corresponds to a bend of half that magnitude.
Center gauges and fishtail gauges [1] are gauges used in lathe work for checking the angles when grinding the profiles of single-point screw-cutting tool bits and centers. In the image, the gauge on the left is called a fishtail gauge or center gauge, and the one on the right is another style of center gauge. [2]
Two types of radius gauges. A radius gauge, also known as a fillet gauge, [1] is a tool used to measure the radius of an object. [2] Radius gauges require a bright light behind the object to be measured. The gauge is placed against the edge to be checked and any light leakage between the blade and edge indicates a mismatch that requires ...
It is used as a measure of the effective size of a gear. The test radius of the master, plus the test radius of the work gear is the set up center distance on a composite action test device. Test radius is not the same as the operating pitch radii of two tightly meshing gears unless both are perfect and to basic or standard tooth thickness. [1]
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
Feeler gauge set (25 pieces, 0.03~1.0 mm measurement range) Measuring the valve clearance of a DOHC engine, between camshaft and tappet (here: 0.004 in ≈ 0.10 mm). A feeler gauge is a tool used to measure gap widths. Feeler gauges are mostly used in engineering to measure the clearance between two parts. [1]