Ads
related to: woodworking straight edge guideebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A pair of straightedges called winding sticks are used in woodworking to make warping easier to perceive in pieces of wood. Three straight edges can be used to test and calibrate themselves to a certain extent, however this procedure does not control twist. For accurate calibration of a straight edge, a surface plate must be used. [2]
The stock is usually thicker than the blade, with the blade being fixed into or onto the stock. The blade typically has parallel edges. The stock is usually held against the edge of a workpiece or drawing board and the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.
The blades on marking knives are made of tool steel, have either a skewed end or a spear point, and the knife edge is bevelled on either one side of the blade or both sides. [4] On single-bevel skewed knives the side of the blade that is bevelled dictates whether the knife is for left-handed or right-handed use, while single-bevel spear point ...
Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.
The tendency for wood that is being cut to direct the saw parallel to its grain. lath. Also called a slat. A thin, narrow strip of straight-grained wood, typically arranged side-by-side with others and used to support roof shingles or tiles, as a backing material for plaster or stucco in walls and ceilings, or in lattice and trellis frameworks ...
Normally, the desired outcome of jointing is an edge which is straight along its length and perpendicular to the face of the board. However, there is another technique often used when gluing up panels, referred to as a sprung joint. [1] In this technique, the desired outcome is an edge which is slightly concave along its length.
Ads
related to: woodworking straight edge guideebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month