Search results
Results from the WOW.Com Content Network
is the voltage at maximum load. The maximum load is the one that draws the greatest current, i.e. the lowest specified load resistance (never short circuit); is the voltage at minimum load. The minimum load is the one that draws the least current, i.e. the highest specified load resistance (possibly open circuit for some types of linear ...
The red curve shows the power in the load, normalized relative to its maximum possible. The dark blue curve shows the efficiency η. The efficiency η is the ratio of the power dissipated by the load resistance R L to the total power dissipated by the circuit (which includes the voltage source's resistance of R S as well as R L):
The wall-plug efficiency is the measure of output radiative-energy, in watts (joules per second), per total input electrical energy in watts. The output energy is usually measured in terms of absolute irradiance and the wall-plug efficiency is given as a percentage of the total input energy, with the inverse percentage representing the losses.
If energy output and input are expressed in the same units, efficiency is a dimensionless number. [1] Where it is not customary or convenient to represent input and output energy in the same units, efficiency-like quantities have units associated with them. For example, the heat rate of a fossil fuel power plant may be expressed in BTU per ...
A low line regulation is always preferred. In practice, a well regulated power supply should have a line regulation of at most 0.1%. [1] In the regulator device datasheets the line regulation is expressed as percent change in output with respect to change in input per volt of the output. Mathematically it is expressed as:
At any instant the power input to a machine is equal to the input force multiplied by the velocity of the input point, similarly the power output is equal to the force exerted on the load multiplied by the velocity of the load. The mechanical efficiency of a machine (often represented by the Greek letter eta η) is a dimensionless number ...
the cooling output at full load in kW; the energy efficiency ratio in cooling mode at full load; the appliance type (cooling only, cooling/heating) the cooling mode (air- or water-cooled) the noise rating in dB (where applicable) Labels for air conditioners with heating capability also contain: the heat output at full load in kW; the heating ...
The output impedance is a measure of the source's propensity to drop in voltage when the load draws current, the source network being the portion of the network that transmits and the load network being the portion of the network that consumes. Because of this the output impedance is sometimes referred to as the source impedance or internal ...