enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cork borer - Wikipedia

   en.wikipedia.org/wiki/Cork_borer

   A cork borer, often used in a chemistry or biology laboratory, is a metal tool for cutting a hole in a cork or rubber stopper to insert glass tubing. [1] Cork borers usually come in a set of nested sizes along with a solid pin for pushing the removed cork (or rubber) out of the borer.

3. Laboratory rubber stopper - Wikipedia

   en.wikipedia.org/wiki/Laboratory_rubber_stopper

   A laboratory rubber stopper or a rubber bung or a rubber cork is mainly used in chemical laboratories in combination with flasks and test tube and also for fermentation in winery. [ 1 ] [ 2 ] [ 3 ] Generally, in a laboratory , the sizes of rubber stoppers can be varied up to approximately 16 sizes and each of it is specific to certain type of ...

4. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole. Plugs are most commonly encountered in the bathroom or kitchen, for use in bathtubs, wash basins or sinks. [1]

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

6. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   A machine screw is screwed into the sleeve, causing the anchor to bend, expand, spread and grip against the inside of the hole or behind it (in hollow contexts such as drywall over stud cavities, or hollow doors). [1] Mollies come in various diameters and grip lengths (shank lengths) for different drywall thicknesses and to support different ...

7. Ground glass joint - Wikipedia

   en.wikipedia.org/wiki/Ground_glass_joint

   Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.