enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Framing side by side units. The erection of a wooden frame in Sabah, Malaysia. Framing, in construction, is the fitting together of pieces to give a structure support and shape. [1] Framing materials are usually wood, engineered wood, or structural steel. The alternative to framed construction is generally called mass wall construction, where ...

3. Engineering drawing - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing

   v. t. e. An engineering drawing is a type of technical drawing that is used to convey information about an object. A common use is to specify the geometry necessary for the construction of a component and is called a detail drawing. Usually, a number of drawings are necessary to completely specify even a simple component.

4. Kick space - Wikipedia

   en.wikipedia.org/wiki/Kick_space

   The kick space is intended to prevent potential toe injuries and allow for closer proximity to a countertop (the toes being the furthest-extending ground-level human body parts). [ 2] Typical dimensions are roughly 4 inches (10 cm) high by 3 inches (7.6 cm) deep. A fully enclosed cabinet base with a kick space.

5. Lumber - Wikipedia

   en.wikipedia.org/wiki/Lumber

   As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...

6. Isometric projection - Wikipedia

   en.wikipedia.org/wiki/Isometric_projection

   Graphical projection. Isometric projection is a method for visually representing three-dimensional objects in two dimensions in technical and engineering drawings. It is an axonometric projection in which the three coordinate axes appear equally foreshortened and the angle between any two of them is 120 degrees.

7. 3D projection - Wikipedia

   en.wikipedia.org/wiki/3D_projection

   A 3D projection (or graphical projection) is a design technique used to display a three-dimensional (3D) object on a two-dimensional (2D) surface. These projections rely on visual perspective and aspect analysis to project a complex object for viewing capability on a simpler plane. 3D projections use the primary qualities of an object's basic ...