Search results
Results from the WOW.Com Content Network
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.
A simple fraction (also known as a common fraction or vulgar fraction, where vulgar is Latin for "common") is a rational number written as a / b or , where a and b are both integers. [9] As with other fractions, the denominator (b) cannot be zero. Examples include 1 2 , − 8 5 , −8 5 , and 8 −5 .
Horizontal pitch (HP) is a unit of length defined by the Eurocard printed circuit board standard used to measure the horizontal width of rack mounted electronic equipment, similar to the rack unit (U) used to measure vertical heights of rack mounted equipment. One HP is 0.2 inches (1/5") or 5.08 millimetres wide.
4.2333 mm. The pica is a typographic unit of measure corresponding to approximately 1⁄6 of an inch, or from 1⁄68 to 1⁄73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
nonstandard. 1⁄1728 ft 3. The cubic inch (symbol in3) is a unit of volume in the Imperial units and United States customary units systems. It is the volume of a cube with each of its three dimensions (length, width, and height) being one inch long which is equivalent to 1/231 of a US gallon. [1]
The actual size of the drive bays differ from their name (e.g., 3 1 ⁄ 2" drive bays are actually 4 inches (101.6 mm) wide, because 3 1 ⁄ 2" refers to the historical platter diameter inside the drive). The newer 2 1 ⁄ 2 inch and 1.8 inch drive bays are specified in
One way to make large numbers or small fractions easier to read, is to use unit prefixes. At some point in time though, the need to relate the two units might arise, and consequently the need to choose one unit as defining the other or vice versa. For example, an inch could be defined in terms of a barleycorn. A system of measurement is a ...