Search results
Results from the WOW.Com Content Network
Alternatively, one rear speaker can be used on its own. This is the type of quad setup used by Seeburg jukeboxes that had quadraphonic sound. [ citation needed ] The Hafler circuit is capable of partially decoding a Dolby Surround track since both share the same operating principles (based on sound phase differences).
The only control common to all Leslie speakers is a dial that controls the master volume. This is normally set up once and then left, since the organ's expression pedal normally controls the volume. Leslie recommended playing the organ at full volume with all stops (drawbars) pulled out and adjusting the volume just before distortion occurs. [13]
During the late 1920s to mid-1930s, small portable PA systems and guitar combo amplifiers were fairly similar. These early amps had a "single volume control and one or two input jacks, field coil speakers" and thin wooden cabinets; remarkably, these early amps did not have tone controls or even an on-off switch. [14]
A speaker L pad is a special configuration of rheostats used to control volume while maintaining a constant load impedance on the output of the audio amplifier. [1] It consists of a parallel and a series rheostat connected in an "L" configuration.
At this frequency, the voice coil is vibrating in the speaker's magnetic field with maximum peak-to-peak amplitude and velocity. The back EMF generated by this movement is also at its maximum. The electrical impedance of the speaker varies with the back EMF and thus with the applied frequency.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
4-pin speaker connector (marked SPK) on motherboard Tiny moving-iron PC speaker uses 4-pin 2-wire connection. In some applications, the PC speaker is affixed directly to the computer's motherboard; in others, including the first IBM Personal Computer, the speaker is attached by wire to a connector on the motherboard. Some PC cases come with a ...
Audio stereo power amplifier made by McIntosh The internal view of a Mission Cyrus One hi-fi integrated audio amplifier (1984) [1]. An audio power amplifier (or power amp) amplifies low-power electronic audio signals, such as the signal from a radio receiver or an electric guitar pickup, to a level that is high enough for driving loudspeakers or headphones.