Search results
Results from the WOW.Com Content Network
Calcium hydroxide has many names including hydrated lime, caustic lime, builders' lime, slaked lime, cal, and pickling lime. Calcium hydroxide is used in many applications, including food preparation, where it has been identified as E number E526. Limewater, also called milk of lime, is the common name for a saturated solution of calcium hydroxide.
An example is when slaked lime (calcium hydroxide) is mixed into a thick slurry with sand and water to form mortar for building purposes. When the masonry has been laid, the slaked lime in the mortar slowly begins to react with carbon dioxide to form calcium carbonate (limestone) according to the reaction:
This contrasts with calcium hydroxide, also called slaked lime or air lime that is used to make lime mortar, the other common type of lime mortar, which sets by carbonation (re-absorbing carbon dioxide (CO 2) from the air). Hydraulic lime provides a faster initial set and higher compressive strength than air lime, and hydraulic lime will set in ...
It is the raw material for the manufacture of quicklime (calcium oxide), slaked lime (calcium hydroxide), cement and mortar. [59] Pulverized limestone is used as a soil conditioner to neutralize acidic soils (agricultural lime). [115] Is crushed for use as aggregate—the solid base for many roads as well as in asphalt concrete. [59]
Agricultural lime, also called aglime, agricultural limestone, garden lime or liming, is a soil additive made from pulverized limestone or chalk. The primary active component is calcium carbonate . Additional chemicals vary depending on the mineral source and may include calcium oxide .
Calcined gypsum is an alternative material in industrial plasters and mortars. Cement, cement kiln dust, fly ash, and lime kiln dust are potential substitutes for some construction uses of lime. Magnesium hydroxide is a substitute for lime in pH control, and magnesium oxide is a substitute for dolomitic lime as a flux in steelmaking. [28]
To make lime plaster, limestone (calcium carbonate) is heated above approximately 850 °C (1600 °F) to produce quicklime (calcium oxide). Water is then added to produce slaked lime (calcium hydroxide), which is sold as a wet putty or a white powder. Additional water is added to form a paste prior to use.
This hydrated lime (calcium hydroxide) naturally turns back into calcium carbonate by reacting with carbon dioxide in the air, the entire process being called the lime cycle. The slaking process involved in creating a lime putty is an exothermic reaction which initially creates a liquid of a creamy consistency. This is then matured for 2 to 3 ...