Search results
Results from the WOW.Com Content Network
Sound cards have a limited sample rate, typically up to 192 kHz. Under the assumptions of the Nyquist–Shannon sampling theorem, this means a maximum signal frequency (bandwidth) of half that: 96 kHz. Real sound cards tend to have a bandwidth smaller than implied by the Nyquist limit from internal filtering. [24]
Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave.In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to that of the message signal, such as an audio signal.
Most amateur digital modes are transmitted by inserting audio into the microphone input of a radio and using an analog scheme, such as amplitude modulation (AM), frequency modulation (FM), or single-sideband modulation (SSB). Amateur teleprinting over radio (AMTOR) D-STAR (Digital Data) a high speed (128 kbit/s), data-only mode.
AM broadcasting is radio broadcasting using amplitude modulation (AM) transmissions. It was the first method developed for making audio radio transmissions, and is still used worldwide, primarily for medium wave (also known as "AM band") transmissions, but also on the longwave and shortwave radio bands.
Wide FM, 20.0 kHz width, ±5 kHz deviation, still widely used for amateur radio, NOAA weather radio, marine, and aviation users and land mobile users below 50 MHz [2] 11K2 F3E Narrow FM, 11.25 kHz bandwidth, ±2.5 kHz deviation – In the United States, all Part 90 Land Mobile Radio Service (LMRS) users operating above 50 MHz were required to ...
In broadcast services, where audio fidelity is important, wideband FM is generally used. Analog TV sound is also broadcast using FM. Narrowband FM is used for voice communications in commercial and amateur radio settings. In two-way radio, narrowband FM (NBFM) is used to conserve bandwidth for land mobile, marine mobile and other radio services.
"Wow" is slow speed (a few Hz) variation, caused by longer-term drift of the drive motor speed, whereas "flutter" is faster speed (a few tens of Hz) variations, usually caused by mechanical defects such as out-of-roundness of the capstan of a tape transport mechanism. The measurement is given in % and a lower number is better.
The channel steps of 9 and 10 kHz would ordinarily require limiting the audio bandwidth to 4.5 and 5 kHz, respectively, without causing any interference to adjacent channels, because the audio spectrum is transmitted twice, once on each side band (i.e. ±4.5 kHz of carrier frequency for 9 kHz channels and ±5 kHz of carrier frequency for 10 kHz ...