Search results
Results from the WOW.Com Content Network
This is also common for motorcycles, and such head/cylinder components are referred to as barrels. Some engines, particularly medium- and large-capacity diesel engines built for industrial, marine, power generation, and heavy traction purposes (large trucks, locomotives, heavy equipment, etc.) have individual cylinder heads for each cylinder ...
In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.
Parts washers were originally developed for use in automotive transmission and engine repair shops as a way to improve the function of simple soak tanks.Soak tanks are vats filled with a mixture of water and detergent, which take hours to "soften" the built-up road grime, fluids, tars and oils enough to be manually rinsed off prior to disassembly and repair.
The hydraulic cylinder consists of a cylinder barrel, in which a piston connected to a piston rod moves back and forth. The barrel is closed on one end by the cylinder bottom (also called the cap) and the other end by the cylinder head (also called the gland) where the piston rod comes out of the cylinder. The piston has sliding rings and seals.
The most common cold solvent operation, this is usually used in small maintenance degreasers using a petroleum or mineral solvent. Usually to remove the bulk of the material, and prepare it for the cleaning tank. Although if the part does not need to be perfectly clean, then the operation can be ended after spraying.
An elevated water tank, also known as a water tower, will create a pressure at the ground-level outlet of 1 kPa per 10.2 centimetres (4.0 in) or 1 psi per 2.31 feet (0.70 m) of elevation. Thus a tank elevated to 20 metres creates about 200 kPa and a tank elevated to 70 feet creates about 30 psi of discharge pressure, sufficient for most ...
An overflow tank that runs dry may result in the coolant vaporizing, which can cause localized or general overheating of the engine. Severe damage may result if the vehicle is allowed to run over temperature. Failures such as blown head gaskets, and warped or cracked cylinder heads or cylinder blocks may be the result. Sometimes there will be ...
While the valve is off, the threads of cylinder and valve must be checked to identify the thread type and condition. The threads of cylinder and valve must be of matching thread specification, clean and full form, undamaged and free of cracks, burrs and other imperfections. Tap marks [note 3] are acceptable and should not be confused with ...