Search results
Results from the WOW.Com Content Network
A typical "portable" dehumidifier can be moved about on built-in casters. A dehumidifier is an air conditioning device which reduces and maintains the level of humidity in the air. [1] This is done usually for health or thermal comfort reasons or to eliminate musty odor and to prevent the growth of mildew by extracting water from the air. It ...
Heat exchangers can be used for a wide variety of uses. As the name implies, these can be used for heating as well as cooling. The two primary types of marine heat exchangers used aboard vessels in the maritime industry are plate, and shell and tube. Maintenance for heat exchangers prevents fouling and galvanic corrosion from dissimilar metals.
Most models with heating elements come with replacement demineralization filters (cartridges, or plastic foam, for the tank, and fabric near the heater in the reservoir) to reduce the amount of minerals entering the system. The cost of these filters is about $10–15 per cartridge or 10-pack for plastic foam, or fabric filters.
This cooled water then acts as the heat sink for the heat pump. Deep lake water cooling uses cold water pumped from the bottom of a lake as a heat sink for climate control systems. Because heat pump efficiency improves as the heat sink gets colder, deep lake water cooling can reduce the electrical demands of large cooling systems where it is ...
The heat sink thermal resistance model consists of two resistances, namely the resistance in the heat sink base, , and the resistance in the fins, . The heat sink base thermal resistance, , can be written as follows if the source is a uniformly applied the heat sink base. If it is not, then the base resistance is primarily spreading resistance:
SS Marine Electric was a 605-foot bulk carrier that sank on 12 February 1983, about 30 miles off the coast of Virginia, in 130 feet of water.Thirty-one of the 34 crew members lost their life due to hypothermia; the three survivors endured 90 minutes drifting in the frigid waters of the Atlantic.
RNLI inshore rescue boat during Falmouth Lifeboat Day, August 2006. A rigid inflatable boat (RIB), also rigid-hull inflatable boat or rigid-hulled inflatable boat (RHIB), is a lightweight but high-performance and high-capacity boat constructed with a rigid hull bottom joined to side-forming air tubes that are inflated with air to a high pressure so as to give the sides resilient rigidity along ...
Succession of forms in the development of the Austronesian boat (Mahdi, 1999) The simplest form of all ancestral Austronesian boats had five parts. The bottom part consists of single piece of hollowed-out log. At the sides were two planks, and two horseshoe-shaped wood pieces formed the prow and stern. These were "sewn" together with dowels and ...