Search results
Results from the WOW.Com Content Network
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
81346-10 also known as RDS-PS (Reference Designation System for Power Supply Systems). [ 13 ] is maintained by ISO/IEC Joint Working Group ISO/TC10/SC10/JWG10. [ 14 ] The latest version 81346-10:2022 is published as a full International Standard, and replaces the previous Technical Specification ISO/TS 81346-10:2015.
DipTrace is a proprietary software suite for electronic design automation (EDA) used for electronic schematic capture and printed circuit board layouts. DipTrace has four applications: schematic editor, PCB editor with built-in shape-based autorouter and 3D preview, component editor (schematic symbol), and pattern editor (PCB footprint).
Thermistor – Resistor whose resistance changes with temperature, up PTC or down NTC; Resistance Temperature Detector (RTD) – Wire whose resistance changes with temperature; Bolometer – Device for measuring the power of incident electromagnetic radiation; Thermal cutoff – Switch that is opened or closed when a set temperature is exceeded
NTC thermistors are widely used as inrush-current limiters and temperature sensors, while PTC thermistors are used as self-resetting overcurrent protectors and self-regulating heating elements. An operational temperature range of a thermistor is dependent on the probe type and is typically between −100 and 300 °C (−148 and 572 °F).
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
is a reference (standard) resistance value. The Steinhart–Hart equation assumes is 1 ohm. The curve fit is much less accurate when it is assumed = and a different value of such as 1 kΩ is used. However, using the full set of coefficients avoids this problem as it simply results in shifted parameters.
PSIM is an Electronic circuit simulation software package, designed specifically for use in power electronics and motor drive simulations but can be used to simulate any electronic circuit. Developed by Powersim, PSIM uses nodal analysis and the trapezoidal rule integration [2] as the basis of its simulation algorithm. PSIM provides a schematic ...