enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...

4. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Metric thread stud bolts: Active: DIN 976-2: Metric interference-fit thread stud bolts: Active: DIN 977: Hexagon weld nuts with flange: Withdrawn: DIN EN ISO 21670: ISO 21670: DIN 979: Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread – Product grades A and B: Active: DIN 980: All-metal prevailing torque type ...

5. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   Bolt preload can also be controlled by torquing the bolt to the point of yielding. Under some circumstances, a skilled operator can feel the drop off of the work required to turn the torque wrench as the material of the bolt begins to yield. At that point the bolt has a preload determined by the bolt area and the yield strength of the bolt ...

6. ASTM A325 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A325

   ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]

7. ASTM F568M - Wikipedia

   en.wikipedia.org/wiki/ASTM_F568M

   ASTM F568M is an ASTM International standard for metric bolts, screws and studs that are used in general engineering applications. It is titled: Standard Specification for Carbon and Alloy Steel Externally Threaded Metric Fasteners. It defines mechanical properties for fasteners that range from M1.6 to 100 in diameter. The standard was ...