Search results
Results from the WOW.Com Content Network
An ornithopter (from Greek ornis, ornith-'bird' and pteron 'wing') is an aircraft that flies by flapping its wings. Designers sought to imitate the flapping-wing ...
The DelFly project started in 2005 as a Design Synthesis Exercise for a group of Bachelor of Science students at the Faculty of Aerospace Engineering of the TU Delft.The flapping wing design was mentored by Wageningen University, [3] the remote control and micro camera integration by Ruijsink Dynamic Engineering, and the real-time image processing by the TU Delft. [14]
The Snowbird is a human-powered ornithopter that was built as a project of the University of Toronto Institute for Aerospace Studies (UTIAS). Snowbird was the first human-powered ornithopter to fly straight and level. [1] [2]
The Chyeranovskii BICh-16 (or sometimes Cheranovsky BICh-16) is an experimental Soviet man-powered ornithopter designed and built by Boris Ivanovich Cheranovsky. [1] The BiCH-16 was a wooden construction tailless design with a braced skid landing gear and the wings moved by pedals. [1]
The Earth-bound entomopter has a 15 to 18 cm wing span. A twin set of wings situated fore and aft of the RCM provide balanced resonant flapping to create not only lift and thrust, but full vehicle control. Wing flapping occurs a 35 Hz constant rate. This biologically inspired aerial robot is classified as a micro air vehicle (MAV) because of ...
– human-powered ornithopter – Snowbird – video of first flight for the Snowbird – Gamera human-powered helicopter; de:HV-1 Mufli – Snowbird – Coolthrust Japan – Snowbird – Gossamer Condor – Mozi video – Mozi drawings, photos etc. – Mozi article
The ornithopter was a high-wing monoplane, with the pilot seated in a recumbent position. Its construction followed conventional glider practice of the time. The fuselage had a bulkhead construction, covered in thin plywood. The wings featured a torsion-box spar and leading edge arrangement, and were also made from thin plywood.
Diagram of the ornithopter design from the patent application. The wedge-shaped objects on the wings (#20) consist of the fabric "valves" (#21), which would blow closed against the supports (#20) on the downstroke. Caldwell then turned to an even more bizarre aircraft design, an ornithopter.