enow.com Web Search

  1. Ads

    related to: candelabra led dimmable bulbs need special switch for 4 amp circuit

Search results

  1. Results from the WOW.Com Content Network
  2. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED. The voltage drop across a lit LED is approximately constant over a wide range of operating

  3. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.

  4. LED lamp - Wikipedia

    en.wikipedia.org/wiki/LED_lamp

    A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

  5. 3-way lamp - Wikipedia

    en.wikipedia.org/wiki/3-way_lamp

    A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...

  6. Holiday lighting technology - Wikipedia

    en.wikipedia.org/wiki/Holiday_lighting_technology

    LED sets can vary greatly. Common is a set of 60 (2 volts per bulb), but white LED sets use two circuits of 30 (4 volts per bulb). Multicolor sets may have special wiring, because red and yellow require less voltage than the newer blue-based ones (blue, emerald green and fluorescent white), but typically come in sets with a multiple of 35.

  7. New Orleans terrorist’s allegiance to ISIS shows group are ...

    www.aol.com/news/orleans-terrorist-allegiance...

    FBI photo of 42-year-old Shamsud-Din Jabbar, identified as the deceased suspect of the New Orleans terrorist attack on New Year’s Day that killed 15 and injured dozens more.

  1. Ads

    related to: candelabra led dimmable bulbs need special switch for 4 amp circuit