enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Enthalpy of sublimation - Wikipedia

   en.wikipedia.org/wiki/Enthalpy_of_sublimation

   In thermodynamics, the enthalpy of sublimation, or heat of sublimation, is the heat required to sublimate (change from solid to gas) one mole of a substance at a given combination of temperature and pressure, usually standard temperature and pressure (STP). It is equal to the cohesive energy of the solid.

3. Dye-sublimation printing - Wikipedia

   en.wikipedia.org/wiki/Dye-sublimation_printing

   The most common dyes used for sublimation activate at 350 degrees Fahrenheit / 175 degrees Celsius. However, a range of 380 to 420 degrees Fahrenheit / 195 to 215 degrees Celsius is normally recommended for optimal color. The result of the sublimation transfer process is a nearly permanent, high-resolution, full-color print.

4. Triple point - Wikipedia

   en.wikipedia.org/wiki/Triple_point

   A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]

5. Sublimatory - Wikipedia

   en.wikipedia.org/wiki/Sublimatory

   A sublimatory [1] [2] or sublimation apparatus is equipment, commonly laboratory glassware, for purification of compounds by selective sublimation. In principle, the operation resembles purification by distillation , except that the products do not pass through a liquid phase .

6. Sublimation (phase transition) - Wikipedia

   en.wikipedia.org/wiki/Sublimation_(phase_transition)

   Solid carbon dioxide sublimes rapidly along the solid-gas boundary (sublimation point) below the triple point (e.g., at the temperature of −78.5 °C, at atmospheric pressure), whereas its melting into liquid CO 2 can occur along the solid-liquid boundary (melting point) at pressures and temperatures above the triple point (i.e., 5.1 atm, − ...

7. Cold finger - Wikipedia

   en.wikipedia.org/wiki/Cold_finger

   Cold finger used in sublimation.The raw product (6) is in the bottom of the outer tube (4) which is heated (7) while under vacuum (through side-arm 3). The sublimated material collects (5) on the cold finger proper, cooled by a coolant (blue) circulated through ports 1 and 2.

8. 7 Ways To Humidify A Room Without A Humidifier, According To ...

   www.aol.com/lifestyle/7-ways-humidify-room...

   This anti-aging eye gel is a must-have for winter — and it's 20% off right now

9. Critical point (thermodynamics) - Wikipedia

   en.wikipedia.org/wiki/Critical_point...

   The commonly known phases solid, liquid and vapor are separated by phase boundaries, i.e. pressure–temperature combinations where two phases can coexist. At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the ...