Search results
Results from the WOW.Com Content Network
The flowrate of purge gas is set by rotameter (FIC) or fixed orifice plate (FO). A low flow alarm (FAL) warns operating personnel that the purge flow has reduced significantly. [8] Pipelines are monitored by measuring the flowrate of fluid at each end, a discrepancy (FDA) may indicate a leak in the pipeline.
Using the Parshall flume flow equations and Tables 1-3, determine the flow type (free flow or submerged flow) and discharge for a 36-inch flume with an upstream depth, Ha of 1.5 ft and a downstream depth, H b of 1.4 ft. For reference of locations H a and H b, refer to Figure 1.
The technique allows non-contact measurement where the heat of the molten metal makes contact techniques and even many non-contact techniques impractical. Nucleonic level sensors are often used in mineral crushing circuits, where an increase in gamma ray detection indicates a void, compared to being filled with ore.
Electronic components used to make a simple water detector: battery, resistor, transistor, water sensor and piezoelectric buzzer for audible alert A water detector is an electronic device that is designed to detect the presence of water for purposes such as to provide an alert in time to allow the prevention of water leakage.
Schematic view of a flow sensor. An ultrasonic flow meter is a type of flow meter that measures the velocity of a fluid with ultrasound to calculate volume flow. Using ultrasonic transducers, the flow meter can measure the average velocity along the path of an emitted beam of ultrasound, by averaging the difference in measured transit time between the pulses of ultrasound propagating into and ...
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
When the direction of flow of a gas stream containing liquid mist is changed abruptly, inertia causes the liquid to continue in the original direction of flow. Separation of liquid mist from the gas thus can be effected because the gas will more readily assume the change of flow direction and will flow away from the liquid mist particles.
As drain voltage is increased, the depletion region of the p-n junction between the drain and body increases in size and extends under the gate, so the drain assumes a greater portion of the burden of balancing depletion region charge, leaving a smaller burden for the gate. As a result, the charge present on the gate retains charge balance by ...