Search results
Results from the WOW.Com Content Network
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
MTR also has a User Datagram Protocol (UDP) mode (invoked with "-u" on the command line or pressing the "u" key in the curses interface) that sends UDP packets, with the time to live (TTL) field in the IP header increasing by one for each probe sent, toward the destination host. When the UDP mode is used, MTR relies on ICMP port unreachable ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
Layer Four Traceroute (LFT) is a fast, multi-protocol traceroute engine, that also implements numerous other features including AS number lookups through regional Internet registries and other reliable sources, Loose Source Routing, firewall and load balancer detection, etc. LFT is best known for its use by network security practitioners to trace a route to a destination host through many ...
On the Windows platform, this command is available only if the Internet Protocol (TCP/IP) protocol is installed as a component in the properties of a network adapter in Network Connections. On the Windows platform running Remote Desktop Services (formerly Terminal Services) it will only show connections for the current user, not for the whole ...
IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing and queued to the appropriate outgoing interface according to their destination address and a set of rules and performance metrics.
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.