Search results
Results from the WOW.Com Content Network
Radio-frequency welding, also known as dielectric welding and high-frequency welding, is a plastic welding process that utilizes high-frequency electric fields to induce heating and melting of thermoplastic base materials. [1] The electric field is applied by a pair of electrodes after the parts being joined are clamped together.
It is a type of welding that uses a welding power supply to create an electric arc between a metal stick ("electrode") and the base material to melt the metals at the point of contact. Arc welding power supplies can deliver either direct (DC) or alternating (AC) current to the work, while consumable or non-consumable electrodes are used.
When welding a common combination like 1.0 + 1.0 mm sheet steel, the voltage between the electrodes is only about 1.5 V at the start of the weld but can fall as low as 1 V at the end of the weld. This decrease in voltage results from the reduction in resistance caused by the workpiece melting.
However, it is one of the easier materials to weld using ultrasonic welding because it is a softer metal and thus a solid-state weld is simple to achieve. [12] Since aluminum is so widely used in the aerospace industry, it follows that ultrasonic welding is an important manufacturing process.
Welding speed – The welding equipment enables adjustment of the relative speed of motion of the workpiece with respect to the beam in wide enough limits, e.g., between 2 and 50 mm/s. Material properties – Depending on conditions, the extent of evaporation may vary, from negligible to complete.
Electric resistance welding (ERW) is a welding process in which metal parts in contact are permanently joined by heating them with an electric current, melting the metal at the joint. [1] Electric resistance welding is widely used, for example, in manufacture of steel pipe and in assembly of bodies for automobiles. [ 2 ]
Candle toppers are cute, open metal lids that often have intricate designs. Like the aluminum foil, they help keep the flames protected from wind and drafts so the wax can melt evenly.
The electrical energy for the percussion welding can be supplied by a transformer, as alternating current (or rectified), or by the discharge of capacitors.Because of the short duration of the arc and of the fact that all of the weld energy comes from this arc, the electrical resistance of the parts to be welded does not affect the amount of heat generated at the weld and substances of ...