Search results
Results from the WOW.Com Content Network
PULHES is a United States military acronym used in the Military Physical Profile Serial System. It is used to qualify an enlistee's physical profile for each military skill . Each letter in the acronym (see box below) is paired with a number from 1 to 4 to designate the service member's physical capacity.
The medical section of the SRP includes a series of medical examinations and evaluations consistent with the PULHES Factor rating scheme, which is used to qualify an soldier's physical profile for each military skill. PULHES stands for physical capacity, upper body, lower body, hearing, eyes, and psychiatric. [9]
American steel grades : AISI/SAE steel grades standard; British Standards; International Organization for Standardization ISO/TS 4949:2016; European standards – EN 10027; Japanese steel grades : Japanese Industrial Standards (JIS) standard and NK standard; Germany steel grades : DIN standard; China steel grades : GB standard; Czech steel ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Specified Minimum Yield Strength (SMYS) means the specified minimum yield strength for steel pipe manufactured in accordance with a listed specification 1. This is a common term used in the oil and gas industry for steel pipe used under the jurisdiction of the United States Department of Transportation .
where is the density of the fluid, is the average velocity in the pipe, is the friction factor from the Moody chart, is the length of the pipe and is the pipe diameter. The chart plots Darcy–Weisbach friction factor against Reynolds number Re for a variety of relative roughnesses, the ratio of the mean height of roughness of the pipe to the ...
The SAE steel grades system is a standard alloy numbering system (SAE J1086 – Numbering Metals and Alloys) for steel grades maintained by SAE International. In the 1930s and 1940s, the American Iron and Steel Institute (AISI) and SAE were both involved in efforts to standardize such a numbering system for steels.
The VPAM scale as of 2009 runs from 1 to 14, with 1-5 being soft armor, and 6-14 being hard armor. [1] Tested armor must withstand three hits, spaced 120 mm (4.7 inches) apart, of the designated test threat with no more than 25 mm (0.98 inches) of back-face deformation in order to pass.